1″ Chip Bristle Brush (RTI-CHIP-1)

1″ Chip Bristle Brush

A workshop and boatyard staple the 1″ chip bristle brush is the go-to applicator for epoxy resin, varnish, antifouling paint, primers, and adhesives where a disposable, natural-bristle brush delivers better control and coverage than a foam applicator. At this price point, the RTI-CHIP-1 is designed for single-use application with solvent-based coatings, making cleanup a non-issue.

Key Features

• Natural Bristle Construction Natural bristles hold and release solvent-based coatings, epoxy resins, and varnishes effectively, providing smooth, even application with good flow and levelling
• 1″ Width Ideal for detail work, trim painting, touch-ups, tight spaces, and small surface areas; also well-suited for stippling epoxy into laminates and fairing compound application
• Chip / Throwaway Design Low cost makes these ideal for single-use application with epoxy, polyester resin, and solvent-based coatings where brush cleaning is impractical or impossible
• Stiff Bristle Action Stiffer than foam applicators; better for working coatings into textured surfaces, porous substrates, and laminate layups
• Versatile Compatibility Suitable for epoxy resin, polyester resin, varnish, antifouling paint, primer, adhesive, and most solvent- and water-based marine coatings

Specifications

• Applicator Type: Natural bristle (chip brush)
• Width: 1″
• Bristle Material: Natural fibre
• Best For: Epoxy resin, varnish, antifouling paint, primer, adhesive application
• Sold: Individually
• SKU: RTI-CHIP-1

Chip Brush vs Foam Brush When to Use Each

• Chip bristle brush (this SKU RTI-CHIP-1) Best for epoxy, polyester resin, varnish, and coatings that benefit from bristle action to work the material into the surface; better for textured or porous substrates
• Foam brush (SKU RTI-FOAM-1) Best for smooth, brush-mark-free finishes on flat surfaces; ideal for antifouling paint touch-ups and high-gloss topcoat work where a lint-free result is critical

Keep both types aboard the right applicator depends on the coating and the surface.

Application Tips

For epoxy application, pre-wet the bristles with solvent or isopropyl alcohol and squeeze out excess before loading with resin this reduces bristle absorption and extends working time. Apply epoxy in thin, even coats and tip off with light strokes to remove air bubbles. For varnish, load the brush lightly and apply with long, smooth strokes in the direction of the grain. Dispose of the brush after use with solvent-based or epoxy coatings chip brushes are not economically cleanable with most marine solvents.

At this price point, keeping a supply of RTI-CHIP-1 brushes on hand means you always have the right applicator ready for epoxy work, varnishing, and coating touch-ups without the hassle of brush cleaning.