Accutech ZeroTorque Feedback Rack Steering System 15 ft. Cable

Smooth, Torque-Free Steering for Outboard and Sterndrive Boats

The Accutech ZeroTorque Feedback Rack Steering System solves one of the most common complaints in mechanical steering: the constant pull and kick-back at the wheel caused by rudder torque. The patented ZeroTorque feedback clutch isolates the helm from propeller and water forces, so the wheel stays where you put it no fighting the helm in a chop, no torque steer under acceleration, no hand fatigue on longer runs.

This 15 ft. cable package is a complete, ready-to-install system with 3.5 turns lock-to-lock, delivering precise, responsive steering with minimal lost motion. It’s an ideal upgrade for center consoles, bay boats, and runabouts in the 1622 ft. range that don’t have hydraulic power assist but still demand confident, comfortable steering.

What’s Included

• M86 Pre-assembled helm with 15 ft. steering cable
• G88NR Non-reversible rack and pinion shaft assembly
• X34 90 bezel for dash mounting

Specifications

• Cable length: 15 ft.
• Turns lock-to-lock: 3.5
• System type: Rack and pinion, mechanical feedback
• Helm: M86 pre-assembled
• Rack assembly: G88NR non-reversible
• Bezel: X34, 90
• SKU: 216-ACCUTECH15
• Barcode: 702755006602
• Weight: 7.9 kg (17.5 lbs.)

Best Use Cases

• Center consoles, bay boats, and runabouts 1622 ft. without hydraulic steering
• Boats with moderate rudder torque where a standard mechanical system feels heavy or pulls
• Owners upgrading from a basic rotary or rack system who want feedback steering without the cost of hydraulics
• Single-engine outboard and sterndrive applications

Parts Desk Insights

The ZeroTorque clutch is what sets this system apart from a standard rack and pinion setup it gives you the road-feel of feedback steering (you can sense what the boat is doing) while blocking the torque that would otherwise kick the wheel out of your hands. The 3.5 turn lock-to-lock ratio is a good balance between responsiveness and effort for most outboard applications. Cable length is the key spec to get right: measure the actual cable run from helm to engine, add a bit for routing, and choose the closest length. If 15 ft. isn’t the right fit for your installation, this system is also available in 13 ft., 14 ft., 16 ft., 17 ft., and 18 ft. cable lengths.