BEP Insulated Stud Double 10mm (IST10MM2S)

BEP Insulated Stud Double 10mm (IST10MM2S)

The BEP IST10MM2S is a double insulated stud terminal designed for high-current marine electrical connections. The extended 10mm stainless steel stud accepts up to three large cable lugs, making it well-suited for consolidating multiple heavy-gauge conductors at a single termination point. A clear polycarbonate cover provides insulation and protection from accidental contact, while snap-out side skirts allow flexible cable entry from multiple directions.

• Extended stainless steel stud accommodates up to three large cable lugs
• Clear polycarbonate cover for insulation and protection
• Snap-out side skirts for flexible cable routing
• Power tapping plate variant available for additional small-cable termination points
• Double stud configuration for dual-circuit or high-load applications

Related Electrical Termination Products

• BEP Pro Installer Link Bar (779LBJ2)
• BEP 777BB4S500 Heavy-Duty Busbar
• BEP 777BB5S650 Heavy-Duty Busbar
• BEP 777Z10W200 Z Busbar
• BEP 777Z18W200 Z Busbar

Parts Desk Insights

Best use case: The IST10MM2S is the right choice when you need to terminate multiple large-gauge cables such as battery cables, windlass leads, or thruster feeds at a single protected stud point. The double configuration is commonly used in engine bay and bilge installations where two circuits share a common ground or positive distribution point. The polycarbonate cover is important in any installation where accidental contact with the stud is a risk. If you need additional termination points for smaller accessory wires at the same location, look for the power tapping plate variant.